tag:blogger.com,1999:blog-2590107172515879818.post5143749866822512219..comments2024-01-21T13:24:41.242-06:00Comments on Killin-It: Ghost in the machine....Unknownnoreply@blogger.comBlogger9125tag:blogger.com,1999:blog-2590107172515879818.post-27243390057064377872013-09-17T19:32:12.990-05:002013-09-17T19:32:12.990-05:00well, replaced the stator and the field coil (both...well, replaced the stator and the field coil (both bench tested perfect) and it did jack shit. bullshit cockfucker. took it apart again and swapped the field coil for the original (also tested perfect) no difference. tapping out. I'm super pissed and even more frustrated. Will be on bicycle in NY, which is fine by me.<br />shit day. shit week. shit month. worst in recent memory.tomhttps://www.blogger.com/profile/09396935192043915547noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-20573151534176035322013-09-16T11:50:19.337-05:002013-09-16T11:50:19.337-05:00That's good news! Wire is cheap. If you have v...That's good news! Wire is cheap. If you have voltage coming from the stator, worst case scenario is just scratch-wiring your charging circuit with some heavy duty fresh wire. aaronhttps://www.blogger.com/profile/02784004974153878511noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-16795798206471999812013-09-16T11:09:15.021-05:002013-09-16T11:09:15.021-05:00unfortunately, the bike will die when it falls bel...unfortunately, the bike will die when it falls below 10.5 volts. When I did the running stator tests this am, I unplugged the stator wires and the field coil wires and tested them individually. I'd run it with a flashlight for a headlight if I could.tomhttps://www.blogger.com/profile/09396935192043915547noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-51165603044257031912013-09-16T10:33:20.978-05:002013-09-16T10:33:20.978-05:00Can you run it without the charging system wired i...Can you run it without the charging system wired in? If you can isolate some variables it would be easier to trouble shoot.Denniehttps://www.blogger.com/profile/12211574836816230621noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-52483121022767396352013-09-16T08:49:09.982-05:002013-09-16T08:49:09.982-05:00Just ran a couple different tests on the stator an...Just ran a couple different tests on the stator and field coil while the bike was running, again, it all tests fine. Wondering if there is something shitty going on in the rats nest wire loom. Anyone want a bike? Cheap.tomhttps://www.blogger.com/profile/09396935192043915547noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-42593862983165588322013-09-16T06:11:02.421-05:002013-09-16T06:11:02.421-05:00Honestly, I've never even done a resistance te...Honestly, I've never even done a resistance test, or checked the leads directly. The stator makes juice when the bike is running. If voltage at the battery goes down after it's started, I replace the stator. Maybe it's not the most thorough or by the book, but it's always been right so far. aaronhttps://www.blogger.com/profile/02784004974153878511noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-39977713658429681412013-09-16T05:22:14.016-05:002013-09-16T05:22:14.016-05:00Just found another stator test to try while bike i...Just found another stator test to try while bike is running, will give it a shot today and we'll see!tomhttps://www.blogger.com/profile/09396935192043915547noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-23718915938511123852013-09-16T04:40:15.278-05:002013-09-16T04:40:15.278-05:00Good point, and it's what I'm starting to ...Good point, and it's what I'm starting to assume as well. I tested the stater by by an ohm tester on the leads. Three leads. 1,2 and 3. Check resistance from 1 to 2, 2 to 3 and 1 to 3. The manual says it should be a .2 ohms. I am at .4 ohms, that could be it? Did not test the stator while running, I should, just did not have a test for that...<br /><br />Thanks for the tip! Now to see if I can get a stator in the next three days and instal it...tomhttps://www.blogger.com/profile/09396935192043915547noreply@blogger.comtag:blogger.com,1999:blog-2590107172515879818.post-41851774234597939582013-09-15T21:12:03.445-05:002013-09-15T21:12:03.445-05:00How did you test the stator? You can check voltage...How did you test the stator? You can check voltage coming from it, directly from the stator leads while it's running to see if it's putting out, but every bad reg/rec I've seen allowed more voltage through, (too much), not less. If voltage drops when it runs I usually assume stator is bad or miswired.aaronhttps://www.blogger.com/profile/02784004974153878511noreply@blogger.com